Prime Community Forum

Hello,
I bought PrimeBlocks for React, installed them and it all worked fine when I ran it by npm start.
But I would like to use it from my web server and therefore I did npm run build.
This succeeded and the build directory was created.
When I put the result to my web server than I see Code link disabled, like on primereact.org website.
Do you know what is the reason? What should I set to see the link enabled?
Kind regards
Petr

Hey there,

Thank you for your feedback. We will try the same steps as you and let you know as soon as possible. If you have any other questions, please do not hesitate to write here.
Best,

Hey there,

We have tried the same steps but unfortunately, ours runs correctly. However, we are willing to solve your problem. Is it possible to send us a reproducer (via codesandbox etc. ) so we can check what the problem is?